Week 5: Transfering code to Arduino ProMini and measuring components

In lab this week, we tried to transfer the test code from Arduino UNO to Arduino ProMini for the prototype to be less bulky and the case containing all the components to be smaller, hence reduce the materials used to 3D-print it out. However, after a lot of attempts on soldering the wires and assembling the circuit, the code could not be transferred to Arduino ProMini board. As the results, the group decided that since the final product will only be a prototype, Arduino Uno will be used as the micro-controller for the bracelet.

Also in this week, the measurement of the length, width and height of each components was obtained to design the plastic case containing these components.